Trinnov Amplitude 8

179.990kr

8-kanals effektforsterker fra Trinnov.

  • 225 watt pr. kanal i 8 ohm.
  • 375 watt pr. kanal i 4 ohm
  • 500 watt pr. kanal i 2 ohm
  • Det ypperste innen hjemmekino

Ikke på lager, tilgjengelig som restordre

Produktnr: AMP8 Kategorier: ,

THE POWER OF SOUND

Integrating seamlessly with your Altitude32 A/V preamp, both visually and technically, the Amplitude8 uses two linear power supplies based on heavy-duty toroidal power transformers, this allows for a powerful three-dimensional soundstage huge dynamic range and bass impact only found in the best commercial theaters.


FEEL THE POWER

The two linear power supplies based on heavy-duty toroidal power transformers allow every module of the Amplitude8 to deliver 225W into 8 ohms, 375W into 4 ohms and 500W into 2 ohms.


STATE-OF-THE-ART PERFORMANCE

The amplification stage of the Amplitude8 also features the industry’s lowest distortion and noise specifications, and its performance is frequency-independent.


INTEGRATION

The Amplitude8 integrates seamlessly with your Altitude32 A/V preamp, both visually and technically.


LOWBEATS.DE (GERMANY)

«With the Trinnov Amplitude 8, the Trinnov Altitude 32 gets a worthy amplifier at its side. Equipped with dual power supply, ground terminal, trigger with feedthrough and DB25 connection. The huge dual power pack and the elaborately cooled Hypex NCORE power amplifiers sound powerful and pleasantly fine-grained: That’s really high end !»

– RAPHAEL VOGT
FARGESort
ANTALL KANALER8.0
INNGANGERRCA, XLR balansert
TYPERTransistor

Spesifikasjoner

Analog Audio Inputs:

CONNECTORS: 1 Balanced (XLR) per channel on each module.
INPUT IMPEDANCE: 47 kOhms, each phase.
INPUT SENSITIVITY: 6.15V RMS balanced input (+18dBu) for 225W into 8 ohms.GAIN 19.2dB.
POLARITY: Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.

Analog Audio Outputs:

CONNECTORS: One balanced output with 5-way binding posts per channel.

Power Output:

8 ohms: 225W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
4 ohms: 375W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
2 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz

Audiophile Grade Performance:

Frequency Response: +-0.5Db From 0Hz To 20 Khz, Load Independent
Damping Factor; > 6000 At 100 Hz; > 2000 At Any Frequency Up To And Including 20 Khz
Signal To Noise Ratio; 125Db Referenced To Rated Output (A-Weighted)
Crosstalk; 85 Db

Power Characteristics:

 Power requirements: 117V AC, 15A Slo Blo main fuse; 230V AC 8A Slo Blo main fuse; 50/60 Hz
Power consumptions: less than 1W at Standby; less than 80W at idle; 1500W maximum by 2 when fully loaded

Weight and Dimensions:

Trigger input : 5 to 12V DC; Steady State.
Dimensions: (W x H x D) 443 x 186,5 x 502 mm

Weight: 59 kg

Du liker kanskje også…

Handlekurv
Duet Audio AS
Skroll til toppen